Xion Community

Hi, I just found out about Xion, and I'm very into designing so I started on a skin right away.

Most stuff works, but I dont get the text functions (fs, fn). Where do I put them. In an empty layer above my track-layer or?

And with font-name, do I enter the name displayed in the Font-Viewer (where you see how it looks) or how its named in the folder?

Also, my Indicators don't really work, but I think I just made a mistake there =)


Thanks in advance,
Foleor

well add tat fs -n- fn after a space after track !!!

say like this -> track fs(24) fn(Arial)

i donno much bout da names... i'm also new 2 skinnin...

-n- besides... wat did u do with da indicators... say tat 1st !

Thanks for the reply mate, I get it now =)

About the indicators, I just made a mistake using it and allready found out what it was, so thats done too =).

About the name of the font, i'll just test both, and see which one works =)

Thanks again,
Foleor

hehehe~ no problemo...

i just finished my 1st skin... -n- i did'nt try 2 do much with da font in it so i had no real idea bout tat

Foleor Wrote:Thanks for the reply mate, I get it now =)

About the indicators, I just made a mistake using it and allready found out what it was, so thats done too =).

About the name of the font, i'll just test both, and see which one works =)

Thanks again,
Foleor

Hi Foleor and Welcome to the Xion Community!

call-me-DD was correct when saying fn(MS Shell Dlg) or fn(Arial). The name is the name that you see in the Font Viewer and not the filename of the font.

Hope that helps!

Cliff